Used EVAPCO LRW 43-4 #9005400 for sale
URL successfully copied!
Tap to zoom
ID: 9005400
Vintage: 2006
Cooling tower, 115 ton
Stainless steel
Water capacity: 350 GPM, 95°F in, 85°F out, 65°F EWB
Fan motor: 15 (inverter duty) HP, elec. spec. 460/3/60
Pump motor: 1.5 HP, elec. spec. 460/3/60
Coil pressure drop: 4.9 PSIG, drives sized for 0" ESP
Unit type: hot-dip galvanized steel, factory assembled, counterflow blow-through
Basin-fan section: constructed with heavy gauge mill hot-dip galvanized steel
Make up float valve assembly: brass float valve with adjustable, foam-filled plastic float
Pan strainer: type 304 stainless steel with large area removable perforated screens
Fan discharge cowls: G-235 hot-dip galvanized steel cowls provided on each fan discharge
Access: G-235 hot-dop galvanized steel circular access doors held in place by wing nuts
Bleed-off: waste water bleed line with adjustable valve provided
Pump: horizontally installed close-coupled centrifugal pump with mechanical seal
Fan wheels: fans forwardly curved centrifugal type, hot-dip galvanized steel factory installed into fan section
Fan shaft bearings: solid shaft of ground and polished steel
Fan motor: enclosed, ball bearing type with 1.15 service factor
Fan drive: V-belt type with taper lock sheaves
Fan end inlet screen: hot-dip galvanized steel screens, 1" wire mesh
Coil: Thermal-Pak coil design of all prime surface steel, encased in steel framework with entire assembly hot-dop galvanized after fabrication
Water distribution system: molded nylon ZM spray nozzles with 1-5/16" diameter opening and internal sludge ring
Fan side inlet screen: PVC coated radial screens
Heat transfer casing: G-235 hot-dip galvanized steel panel construction, separable from basin section
Eliminators: constructed of inert PVC
2006 vintage.
EVAPCO LRW 43-4 is a 4-circuit recirculating, heat exchanger chiller developed by EVAPCO. This equipment offers improved efficiency, reliability, and cost savings for a variety of applications. The heat exchanger is built for condensing temperatures up to 176°F and evaporating temperatures up to 65°F. LRW 43-4 is powered by its own separate motor and compressor as well as compatible with existing motors and compressors. For cooling, a mixture of water and refrigerant is circulated throughout the system with a Danfoss Variable Frequency Drive (VFD) pump, providing adjustable flo to ensure optimal performance and energy efficiency. The 3-speed VFD chiller allows for improved energy savings compared to standard chillers. The primary purpose of EVAPCO LRW 43-4 is to move heat from a hot hydronic fluid to a cooler refrigerant. The refrigerant is then cycled back to the condensing unit and finally to the evaporator, where the heat is finally dispersed. This process creates a consistent cooling effect inside the chiller. The outer shell is constructed from stainless steel cabinet with expanded insulation for added protection against extreme temperatures. The unit also contains an internal safety pressure switch, diagnostic junction box, reversing valve, filter dryer, and pressure regulator. Overall, LRW 43-4 recirculating, heat exchanger chiller is an efficient way to cool a variety of applications, while saving on operational costs. Its stainless steel construction increases durability and offers a longer operating life span. Its adjustable flow rate, wide cooling range, and insulation cover make the machine ideal for any application.
There are no reviews yet